Voopoo Drag S3 review, the spec sheet checked against published tests

Par Thomas Leclerc5 October 20269 min de lecture

The Voopoo Drag S3 follows the compact Drag formula with one headline argument, more battery in a body that stays compact. Spec sheets agree on the basics, then part ways as soon as you look at pod capacity, compatible coils or the real battery gain. We set the manufacturer's sheet against several retailer listings and the published reviews to separate what holds up from what is sales copy.

The Drag S3 at a glance, with the spec sheet cross-checked

The Drag S3 is a pod mod with a built-in 3000 mAh battery, adjustable from 5 to 60 W, that works with Voopoo's PnP X range of cartridges and coils. It runs mouth to lung (MTL) or direct lung (DTL) depending on the cartridge and coil fitted. Its strongest feature is the capacitive lock, while the flaws reviewers flag range from a fiddly airflow ring and noise to buttons that scratch easily.

The table separates what Voopoo publishes from what only retailer listings state, in the absence of an official figure.

Specification	Value	Source
Battery	3000 mAh, built-in	Manufacturer
Output	5 to 60 W	Manufacturer
Output voltage	3.2 to 4.35 V	Manufacturer
Resistance range	0.1 to 3.0 ohms	Manufacturer
Charging	USB-C, 5 V at 2 A	Manufacturer
Screen	0.96 inch TFT	Manufacturer
Materials	zinc alloy, leather-effect panel	Manufacturer
Pod capacity	2 ml (TPD version)	Manufacturer
Modes	Smart, RBA, Eco	Retailers and reviews
Dimensions	124.25 × 33 × 28 mm	Retailers
Weight	150 g	Retailers

Voopoo also lists a 5 ml standard cartridge, but UK rules cap refillable tanks at 2 ml, and the UK listing we checked carries the 2 ml TPD version.

Design, screen and the capacitive lock

The zinc alloy chassis carries a textured leather-effect back, offered in ten colours on the manufacturer's page, which publishes neither dimensions nor weight. The 0.96 inch TFT screen shares the front face with the fire button and two adjustment buttons, and offers three display themes.

The headline change sits under your thumb. The fire button carries a capacitive sensor that unlocks the device on contact and locks it again the moment the finger lifts. Voopoo advertises several unlocking options, set from the menu, and the aim is to stop accidental firing when something presses the button in a pocket or bag.

Drag S3 battery life, and what the 25% claim really means

The Drag S3 carries 3000 mAh against 2500 mAh for the Drag S2, according to Voopoo's own sheets. Capacity therefore rises by 500 mAh, which is 20%. Voopoo nevertheless advertises 25% more runtime, pointing to a more efficient battery without publishing how it measured that.

The five point gap cannot come from capacity alone. Treat the 25% figure as a manufacturer claim, and the 20% as the number both spec sheets confirm. Another quiet change, the maximum output voltage moves from 4.2 V on the S2 to 4.35 V on the S3, while the power ceiling stays at 60 W.

Real runtime depends mostly on the coil and the wattage. A 0.8 ohm PnP X coil at 12 to 16 W draws far less from the battery than a 0.2 ohm coil pushed towards 60 W, so no single battery life figure means much for this device.

Three modes and the PnP X platform

The device's versatility rests on two things, the choice of firing mode and compatibility with the PnP X cartridges and coils. It is also where the spec sheets contradict each other most.

Smart, RBA and Eco

Smart mode sets the power according to the coil it detects, to stay within what that coil can take. RBA mode opens the full 5 to 60 W range for manual adjustment, and Eco mode limits consumption to stretch the battery.

Compatible coils and the 0.15 ohm question

Voopoo publishes a recommended wattage for each PnP X coil. The table lists those values, to be read against the device's 60 W ceiling.

PnP X coil	Style	Recommended power
0.15 ohm	DTL	60 to 80 W
0.2 ohm	DTL	40 to 60 W
0.3 ohm	DTL and RDL	32 to 40 W
0.45 ohm	RDL	25 to 32 W
0.6 ohm	MTL and RDL	18 to 23 W
0.8 ohm	MTL	12 to 16 W
1.0 ohm	MTL	10 to 13 W

The 0.15 ohm coil is the awkward one. Its recommended range starts at 60 W, exactly the device's ceiling, and sources disagree on whether it works at all. At least one UK kit ships with it pre-installed and a UK review ran it at 60 W, while one French retailer's test reports the S3 refusing it.

In practice, the comfortable range runs from 0.2 to 1 ohm, where every recommended wattage stays within the 60 W limit. Our guide on choosing a vape coil explains how resistance shapes the draw.

What the 2 ml UK kit actually contains

UK rules cap refillable tanks at 2 ml and nicotine e-liquid at 20 mg/ml in 10 ml bottles, so the Drag S3 sold here is the TPD version. What comes in that box is less settled. Voopoo's own TPD package list names a 2 ml MTL cartridge with 0.6 and 0.8 ohm coils, a 510 drip tip, a PnP X platform card, a USB-C cable and the manual.

UK retailers tell a different story. One UK listing we checked describes a 2 ml DTL cartridge with a 0.15 ohm coil pre-installed and a 0.3 ohm spare, another sells the kit as a DTL edition, and one UK review notes that the MTL cartridge is sold separately here. Check the box contents on the listing before ordering, especially if you want a tight mouth to lung draw from the start.

What published reviews report

Ecigclick's review, published in November 2025, scores the device 9 out of 10. The reviewer tested both the MTL and DTL cartridges, praised the flavour from the PnP X tank, the design and the fast charging, and reported close to two days between charges on a 0.3 ohm coil at 40 W. By that account, the lock settings menu offers touch lock, a button lock triggered by two quick presses, or no lock.

The same review lists its reservations. The pod has to come out of the device to be filled, the screen's definition is modest and some themes shrink the figures, and low resistance coils get through liquid quickly. Charging while vaping is supported, but it slows the charge.

Taffe-elec, a French retailer, published a long-form test in January 2026 with a score of 8 out of 10. That test found the touch lock responsive and never unlocked by accident in a pocket or bag. It flagged three flaws: noise while vaping, an airflow ring on the MTL cartridge that cannot be turned one-handed because the round, magnetic cartridge spins in place, and plastic adjustment buttons that scratch quickly.

Drag S3 or Drag X3, which one to pick

Launched alongside the S3, the Drag X3 reaches 80 W according to Voopoo, runs on a single 18650 or 21700 cell sold separately, replaces the buttons with a 1.66 inch touchscreen and ships as standard with a DTL cartridge and 0.15 and 0.3 ohm coils.

PnP X cartridges and coils move freely between the two, so the decision lies elsewhere. The S3 suits someone who wants a built-in battery, physical buttons and a compact body. The X3 is aimed at vapers who prefer a removable cell and more headroom for direct lung vaping, with the obligations that come with it.

A removable cell means reading its datasheet and carrying it in a case, which our comparison of 21700 and 18650 batteries covers in detail.

FAQ

These answers cover practical points that retail listings tend to skip.

What e-liquid suits the Drag S3? Voopoo recommends 50 to 70% vegetable glycerine, with nicotine at 20 mg/ml or less. A thinner liquid generally suits the 0.8 and 1 ohm coils better, and a higher glycerine blend the lower resistances.

Do integrated coil PnP X pods work on it? Yes. Voopoo lists integrated PnP X cartridges at 0.3, 0.8 and 1 ohm among the compatible options, which removes coil changes altogether. The manufacturer also warns that the cartridge supplied may be the older or the newer version, both fully functional.

Can I fit a different drip tip? Yes. The mouthpiece uses a standard 510 thread and comes off, so a 510 drip tip of your choice can replace it to change the feel without swapping cartridges.

How long does a full charge take? Voopoo does not publish a charging time. The battery accepts 5 V at 2 A through USB-C, and a mains adapter able to supply those 2 A gives the fastest charge the manufacturer allows.

What safety protections does the device have? The manufacturer lists six: overtime firing, overheating, overcharging, low battery, output over-current and short circuit. They sit alongside the capacitive lock, but the device still belongs away from direct heat.

What to take away from the Voopoo Drag S3

Once the spec sheets are cross-checked, the Drag S3 comes down to a 3000 mAh battery in a compact body, a capacitive lock that reviewers rate and very broad PnP X compatibility, provided you stay between 0.2 and 1 ohm. The verifiable battery gain is 20% more capacity, and the kit sold in the UK holds 2 ml.

Its limits are well documented, from a fiddly airflow ring to noise and buttons that scuff. For a vaper who wants mouth to lung now and the option of direct lung later without changing device, the Drag S3 remains a coherent choice, and the PnP X platform leaves room to change cartridges as preferences shift.